Xiaomi Mijia Omni Robot Vacuum Mop 2 M30 PRO Automatic Water Device Spare Parts Kit Original Accessories Kit for Xiaomi Mijia Omni Vacuum Mop 2 M30 PRO

Note: Only the automatic water up and down unit is included, not the robot vacuum mop and installation service.

No need to change the water manually, completely free your hands.

Compatible product: XIAOMI Omni Robot Vacuum Mop 2 C102CN.

Automatic water up and down, no need to change the water.

Complete self-cleaning with dust collection station.

Automatically inject clean water and automatically remove sewage, without manual participation in the whole process, to achieve fully automatic work.

Automatic celestial cleaner.

Exclusive cleaners can be purchased separately, and the dust collection station will automatically add the right amount of cleaner each time you use it.

It is more convenient than manual operation, and effectively reduces the problems of air bubbles and odors generated when mopping the floor.

Please confirm the installation environment before use.

1. A height of more than 28cm needs to be reserved above the base.

2. The water pressure of the tap water source is 0.14-0.8MPa.

3. Floor drain/wall outlet height ≤20CM.

4. Power socket (will not be exposed to water).

Installation display.

Optionally installed on the balcony.

Optionally installed in the toilet (dry area).

Optionally installed at the bottom of the cabinet.

Can be installed in the living room.

Optionally installed in the kitchen.

You can refer to the installation plan.

Option 1: Reserve buried water pipes in the wall.

1. Power socket.
2. Water inlet.
3. Angle valve.
4. Water outlet (diameter 25mm).
5. Floor drain (sewage outlet).

1. It is recommended that the height of the water inlet from the ground (d1) is about 55-60cm, if the terminal of the sewage pipe is a floor drain, there is no special drainage size requirement, if the terminal of the sewage pipe is a wall outlet, the recommended height (d2) of the water outlet from the ground is less than 20cm (recommended height is 15cm).

2. The pre-embedded pipe needs to be installed with a separate angle valve to control the water inlet.

3. The recommended water inlet pressure is ordinary municipal water pressure (0.14MPa~0.8MPa).

Option 2: wall opening.

1. The location of the opening on the wall must meet the basic requirements for installation (with water source and drainage, such as balcony, bathroom, kitchen, etc.)

2. It is recommended that the height (d3) from the center of the hole on the wall to the ground should not be higher than 15cm, so as not to affect the appearance, and the diameter of the hole should be 3cm.

Packing list of automatic water supply and discharge device:

Up and down water module x 1
3-point T-type elbow x 1
3-point L-type plug connector x 1
2-point right-angle elbow x 1
Control box x 1
3-point locking plate x 8
2-point locking plate x 7
Adaptor connector x 1
Water tee valve x 1
3-point water pipe x 1
2-point water pipe x 1
Wire wrapping pipe x 1
Cable clamps x 1
Manual *1